Manuals

Installing the Discus

by
  1. First slide the ceiling canopy over the cord
  2. Hang the fixture at the desired height, using the black ‘hook’
  3. Mount the porcelain lamp on the fixture as shown in the pictures below. Make sure that the fixture is all the way down, so it can spread it’s ‘wings’.
  4. Put the grey cap in position.
  5. Fix the ceiling canopy by sliding it all the way up, tightly to the ceiling and tighten the screw.
  6. Done! Enjoy!

    Taking it out: just gently and slowly pull it out by the cord. When the ‘wings’ stick out you can squeeze them and pull it completely out.

    When following these steps and doing them with caution it will work every time.

  • The fixture with the cap
  • Squeeze the wings downwards and enter it in the hole of the lamp.
  • Gently push it down, untill the wings are spread completely
  • Now it can’t fall anymore! Find the right balance.
  • Finaly lower the grey cap and put it in place.
  • Done!

Instructions

by

Instructions

  1. First slide the canopy over the cord
  2. Hang the fixture at the desired height, using the black hook
  3. Mount the porcelain lamp on the fixture as shown in the pictures below. Make sure that the fixture is all the way down, so it can spread it’s ‘wings’.
  4. Fix the canopy
  5. Done! Enjoy!

    Taking it out: just gently and slowly pull it out by the cord. When the ‘wings’ stick out you can squeeze them and pull it completely out.

    When following these steps and doing them with caution it will work every time.

  • Squeeze the three ‘wings’
  • Gently push it down the neck of the lamp, still squeezing
  • Push it down further until it is all the way down.
  • Now it can spread its wings and it hangs safely

Manual Booklamp

by

Inserting the fixture into the lamp is easily done following the steps in these pictures. For the most equal spreading of light it is best to have the leds facing sideways. You can see which way is up on the photo’s.

Taking the fixture out is even more easy: gently pull on the cord until it comes out.

  • This way up…
  • Bend the wings and push it through the hole
  • All done!

Manual-hls

by

Instructions

  1. First slide the ceiling cup over the cord
  2. Hang the fixture at the desired height, using the black hook
  3. Mount the porcelain lamp on the fixture as shown in the pictures below. Make sure that the fixture is all the way down, so it can spread it’s ‘wings’.
  4. Fix the ceiling cup
  5. Done! Enjoy!